We are interested in profiling batteries for low power devices and would like to made profile with slow discharge rate to better understand how batteries behave in our devices.
Currently there is limit to 1M itterations which prevents battery profiling with slow discharge.
Do You have plans to increase this limit?
Hi,
We don’t have any plans yet to increase this.
How would your profile setting look like to get higher number than 1M iterations?
Best regards,
Björn
Hi,
our settings which gives 1.2M iterrations are:
Battery capacity: 2700mAh
Current high: 100mA
Time high: 0.08s
Current low: 0.1mA
Time low: 1s
Hi Björn,
I understand that this might not be the most pressing request. However, it would be good to get some direction on this matter. If there are no plans to increase the number of iterations, then perhaps you could suggest an alternate method for testing our products under these conditions. Ideally, the high current and time would remain the same, as this mimics our application.
Hi,
This is a very minor change so most likely this will be increased in next software release.
Best regards,
Björn