Nothing is printing on UART Console

When linking the TX pin from the Nucleo-L053R8 board to the RX pin on the OTii, and grounding (GND) to the digital ground (DGND) of the OTii, and activating UART with a baud rate set to 9600, followed by initiating the UART log and record function, no output appears on the OTii console. Is there an error in my procedure?

When I connect the controller using USB and open Tera Term, I am able to read the data.

what will be the wrong part in my case?


So sorry for not responding to this post.
Have this been sorted out or do you still need support?

Best regards,